Then unscrew the hinges from the cabinets themselves using a screwdriver.
Can i spray paint cabinet handles.
And spray painting the hardware takes things up a notch.
Instead of settling for hardware in its.
Because it is hard to spray the underside of a drawer handle.
Holding the can 8 inches from the hardware apply one light coat of the spray paint color of your choice to cover all surfaces of the hardware.
First sand any damaged areas on the doors or paint cabinet frames with 320 grit sandpaper to remove burrs or ridges then fill the areas with spackling compound photo 3.
Screw a drawer pull into each end with the body of the pull extending out from the holes.
I usually use one of the two.
I wanted them replaced with satin nickel farmhouse style hardware.
A reader asked if you can spray paint door knobs without removing them and while it is tempting just take them all off to spray paint.
Bend down and move around the entire piece so you coat all surfaces.
Durable cabinet hardware is worth keeping even if its finish is outdated or no longer suits the decor of the room.
Hinge removal unscrew the hinges from the cabinet doors and remove the doors.
I also couldn t decide at first whether i wanted a black matte finish on the hardware throughout the room for a minimalist look or to add some bling with gold.
But the hinges well they were a whole other story and the main subject of today s post.
Some paint cabinets like ours have a catalyzed lacquer finish that s very hard.
Then you can hold the piece of wood and spray the pulls inside outside and underneath.
And by hardware i mean the cabinet door knobs and drawer pulls as well as the pantry doorknobs.
By spray painting the hinges we saved around 100 00.
Spray each cabinet pull using smooth even strokes to create a drip free finish.
Primer won t form a good bond to this surface unless you scuff it up first.
Use spray enamel for the hinges because if you prepare the hinges properly it s less likely to chip and peel when you open and close the doors than paint.
You can see here where i spray painted my shower using the same process and the results were amazing but even though i taped off every bit off our bathroom there was still over spray on our master closet.
The current cabinet handles were very dated and i wanted to swap them for a more sleek and modern design.
I drilled holes in each end of a piece of 3 4 inch wood about 1 wide x6 inches long.